Detailed Product Attribute
Model : HY-E600#
Appearance : Translucent
Hardness (A°) : 0-2
Mixing Ratio : 11
Description of Addition Molding Silicone
HY- E600# additionmolding silicone is generally named
two-component silicone rubber, Part A is aflowable liquid, part B
is the curing agent. It features an exceptionalfluidity and good
operability. The mixing ratio is 1:1, mainly be suitable formaking
masks, arms, legs, and other FDA molds application.
Applications of Addition Molding Silicone
HY- E600# additionmolding silicone could be mainly used for making
concrete stones, precisionmolds, PU molds, for life casting, fabric
finishing, seal for electroniccomponents and solar circuit board,
trademark decoration. etc.
Technique Data of HY-E600# molding silicone
Operating time (Mins 25°C)
Curing time (Mins 25°C)
Density ( g/cm 3 )
Tensile-strength( kgf /cm2 )
Tear-strength (kgf /cm2 )
OPERRATING INSTRUCTION :
1. Stirpart A and part B with right mixing ratio evenly. And get
the mixture forvacuum-pumping. (If there is no vacuumizer, you can
just pour the mixtureslowly from the corner so that less bubbles
2.Enclose the product (the original model) with four plastic
plates or woodenplates.
3. Cleanyour products and brush a layer of release agent(detergent
or soap water) onyour product.
4. Pourthe mixture with correct mixing ratio into the model frame.
Afterabout 2-4 hours, when the silicone cured, get out the original
model, and thereyou get a finished addition cured silicone mold .
SHELFLIFE: Twelve (12) months fromdate of shipment when stored at 24°Cin
original unopened packages.
PACKAGE: Packed in clean 20kg/pail, 200kg/pail.
More information , pls contact with Miss Nancy at any time